|
|
| |
|
Hotspot
Brick and Stone Sealer |
|
Brick
and Stone Sealer is a solvent base combination of
resins, oils and special compounds formulated for
sealing and protecting natural brick and stone on fire
place surrounds. The sealer allows brick and stone to
breathe. |
|
|
|
| |
|
|
|
|
|
Order
Online >>>> |
|
|
| Product
Information and Availability |
| Manufacturer |
Hotspot |
| Product |
Brick and Stone
Sealer |
| Availability |
Generally in Stock |
| Shipping
Charges |
Carrier
Delivery Only
(view
details) |
|
Prices and Ordering |
View
Prices &
Order Online |
 |
|
|
|
|
|
| |
|
|
|
|
Description
Brick and Stone
Sealer is a solvent base combination of resins, oils and special
compounds formulated for sealing and protecting natural brick
and stone on fire place surrounds. The sealer allows brick and
stone to breathe.
It will make
the surface strongly repellent to oil, water, dirt and dust.
Food and drink spillages can be easily removed as they remain on
the surface and are not absorbed.
Brick and
Stone Sealer will enhance the natural beauty of brick and stone.
Depending on the nature of the brick or stone it can slightly
deepen the colour. |
 |
Directions for use
-
Ensure surface to be
treated is cool
-
it is very important
that the surface is thoroughly cleaned of dust with a vacuum to
remove all loose dust
-
For the best results use
fireplace cleaner to
remove any stains
-
Remove screens, fixtures
etc. and protect floors and carpets
-
Working area to be well
ventilated
-
Wear protective gloves
-
Pour Brick and Stone
Sealer into a clean tray or saucer and apply by brush or lint free
cloth (Application by brush may cause streaking)
-
1 coat should be
sufficient for indoors surface coverage but for greater protection
outdoors apply 2 or 3 additional coats, ensure that thorough
cleaning is achieved again between each coat
-
Leave to dry for 2-4
hours between coats, and allow 2-4 hours before use, but where
possible leave to dry over night - then heat resistant to 90°C
-
Coverage, depending on
porosity of stone, approximately 5-8m² per 500ml
It is recommended that a
small unobtrusive area is tested for suitability prior to complete
application. Not suitable for reconstituted stone.
|
|
|
|
|
