The EFC16 is an electronic speed control for manual operation of exodraft chimney fans for installation in the LK Fuga series. The speed of the chimney fan motor can be controlled continuously with the EFC16 control and the capacity of the chimney fan can be varied in this way from 25 to 100%.
This allows you to customise your chimney fan to your current requirements, regardless if you are igniting the fire, adding fuel to the fire or continuous heating.
An on/off switch is integrated in the knob of the speed control; also, a minimum trimmer and an LED are installed that lights up when the control is in operation.
The EFC16 control has a knob with which the chimney fans can be switched on and off, and the chimney draft can be adjusted to the desired level.
The further the knob is rotated to the right after it has passed the on/off point, the slower the chimney fan.
A repair switch REP-AFB or equivalent must be attached to the chimney for the EFC16 control.
Note that the EFC16 must be installed by an authorized electrician.
This product is drop shipped to you directly from the manufacturer Exodraft, or via a UK stockist.
Delivery will normally be 1 to 2 working days.
Simple and Effective I used this controller to replace an old model which had failed. This one is simple and effective although it needs a little adjustment during the course of installation. Main negative: it is very expensive for what it is.
(04/03/2013) Michael Bailey - Ashford, Kent